Brake Bleeding

Revision as of 23:01, 3 January 2013; view current revision
<-Older revision | Newer revision->

1. Bleed the master cylinder (sometimes called "bench bleeding" but can be done while installed in the car)
2. Bleed the front wheel cylinders
3. Bleed the rear wheel cylinders

Method 1

The fluid prevents air from going back up into the cylinder.

1. Put about 1" new fluid in a clear glass
2. put a hose from the bleeder to the bottom of the glass, making sure the new fluid covers end of hose
3. Crack the bleeder slightly
4. pump the brake pedal while you watch the glass. When air bubbles stop coming out, it's done.
5. tighten bleeder
6. top-up the master cylinder
7. bleed the next wheel cylinder

Method 2

Discussion: Bleeding the brakes.....on your own

photo  photo  photo  photo  photo  photo 

Traditional Method

1. loosen bleeder
2. push brake pedal down and hold it down
3. tighten bleeder
4. let brake pedal up
5. repeat until clean, steady stream fluid comes out