User Login    
 + Register
  • Main navigation
Login
Username:

Password:


Lost Password?

Register now!
Fast Search
Slow Search
Google Ad


[Datsun 1200 encyclopedia]

Carburettor Diagnosis

Revision as of 01:27, 24 April 2012; view current revision
<-Older revision | Newer revision->

Datsun 1200 encyclopedia | Recent changes | Edit this page | Page history | Switch to MediaWiki mode

Printable version | Disclaimers | Privacy policy | Current revision
Categories: Hitachi 306 Carburetor | Fuel System

Before replacing your carburetor, check to see if it really is bad. Perhaps it just needs correct Adjustment or the problems you have experienced are related to ignition or other causes.

Contents

How Can I Tell if I Need to Repair or Check my Carburetor?

Carb-related problems include:

  • won't idle under 800 rpm
  • non-steady idle speed
  • engine keeps running when ignition turned off (dieseling)
  • poor mileage
  • stumbling when accelerating
  • misses or lacks power or at high speed
  • black smoke from tailpipe. Definitely a carb problem, probably the Choke or Power Valve
  • engine won't start. More likely this is not a carb problem, but some other problem
  • etc.

Now, some of these symptoms can also be caused by electrical or other causes. So see the Carburetor Adjustment page to rule this out.

Engine Won't Idle

If your engine will start, and will run if you hold the pedal down but will not idle on its own:

Not a cause:

  • Plugged fuel filter. If this was the case, it would get worse as you rev the engine

Potential Causes:

Anti-diesel Valve Troubleshooting

The Anti-diesel Valve started with 1973 models and is also known as the idle cutoff solenoid. This is an electrical wire hooked up to the Idle circuit of the carburetor.

1006.jpg
Anti-Diesel solenoid valve

If your carburetor has one of these, the carburetor can run well, but it won't idle at regular speed unless properly connected to wiring.

See Anti-diesel valve Troubleshooting

High Idle Speed

The A12 engine is very smooth and quiet. High idling is usually caused by a vacuum leak (unless your carburetor is shot).

Also See: