User Login    
 + Register
  • Main navigation
Login
Username:

Password:


Lost Password?

Register now!
Fast Search
Slow Search
Google Ad


[Datsun 1200 encyclopedia]

Engine Trouble Diagnosis

Revision as of 11:38, 12 December 2006; view current revision
<-Older revision | Newer revision->

Datsun 1200 encyclopedia | Recent changes | Edit this page | Page history | Switch to MediaWiki mode

Printable version | Disclaimers | Privacy policy | Current revision
Category: Engine Mechanical

Contents

Engine Will Not Start

but cranks normally

possible cause -remedy

(a)dirty or corroded distributor points. -clean or renew and adjust points

(b)carburettor flooding -check needle valve and float, clean out fuel system

(c)moisture on high tension wire and/or inside distributer cap. -dry out high tension wires and cap

(d)dirt or water in carburettor or fuel system. -clean out carburettor and fuel system

(e)incorrectly set spark plug gaps. -reset spark plug gaps to specification

Verify spark is strong enough to jump in the cylinder. Rare failures will produce a spark when the plug is grounded outside the engine, but won't jump under higher cylinder pressures.

(f)faulty coil or capicitor. -test and renew faulty components.

(g)faulty high or low tension wires. -test and renew faulty wires.

(h)fuel vapor lock. -check source of vapor lock and insulate against heat.

(i)faulty fuel pump. -test and overhaul fuel pump.

(j)incorrectly set ignition timing. -check and retime ignition.

(k)broken or short-cicuited low tension lead to distributer points. -test and renew lead.


weak or erratic cranking

(a)weak or faulty battery. -recharge or renew battery.

(b)fault in starter lead or solenoid. -test and renew faulty components.

(c)faulty starter. -test and overhaul starter.


Engine Stalls

(a)idling speed set to low -readjustidling speed stop screw

(b)idling mixture to rich or lean -readjust idling mixture screw and idling speed screw