The 1984 Nissan Competition Catalog listed conversion parts to fit an H165 rear axle assembly to the Datsun 1200.
[edit]
Overview
Datsun 1200 utes came H165 rear axle assembly. However there are several differences from the Sedan & Coupe. However the B110 powered by L14 engine (PB110) also came with H165 which is a direct bolt-in for Sedans & Coupes. Datsun Competition made these PB110 parts available.
The 1200, B210 and 210 models came with either the H145A (to 8/74) or H150 (from 9/74) 3rd members. For competition it is suggested that the H165 3rd member be fitted. To adapt the H165 3rd member the entire axle housing must be changed. For a complete listing of H165 R&P set and LSD units, please refer to page 29.
[edit]
Parts List
43010-H2551 1200 AXLE HOUSING (COUPE ONLY) * [H25 is PB110 part] 38162-G1000 AXLE ASSY FOR 43010-H2551 * [G10 is newer B120 part]
43010-G1051 B210 AXLE HOUSING (COUPE ONLY) 38162-G1000 AXLE ASSY FOR 43010-G1051
43010-W6250 B310 AXLE HOUSING * same as A10 wagon housing 38162-W8500 AXLE ASSY FOR 43010-W6250
The following parts are required to complete the conversion: * 43036-H5000 AXLE SHIM (0.75.MM) * 43036-H5001 AXLE SHIM (0.15MM) * 43036-H5002 AXLE SHIM (0.225MM) * 43036-H5003 AXLE SHIM (0.3MM) * 43070-01L00 AXLE BEARING SPACER (2) * 43215-H5000 AXLE BEARING (2) * 43252-H1010 OIL SEAL (2) * 43255-H1000 BEARING COLLAR (2) 1200/B210 only * 43236-H5000 GREASE CATCHER (1200/B210 only) (2) * 43239-H5000 PACKING 1200/B210 only (2)
¤